5, the processing size has errors or malfunctions
Is the whole machine and computer grounded properly: Ground the device and computer well.
Is the signal line normal: Replace the signal line.
Computer operating system failure or virus infection: Reinstall the operating system or antivirus.
Is the computer running properly: replace or dispose of the computer.
The power supply is unstable or has an interference signal: install a voltage regulator or eliminate interference signals.
Whether the application software is normal: Reinstall the driver software for the software and motion control card.
Whether the processing parameters are set correctly (such as layout, etc.): reset the corresponding parameters
Whether the machining program is written normally: Check the programmed machining program and modify it until it is normal.
6, the slider movement is not ideal
Is the trolley slide and slider dirty: clean the slides and sliders.
Whether the rails are contaminated: Clean the rails and add lubricant.
Is the transmission gear loose: tighten the transmission gear
Is the drive belt loose: Adjust the belt to tight.
